Kanthal® SW 782

Depending of surface finish requirements, the coating may be machined by turning or grinding. For rougher surface, turning using carbide tools, light cuts and efficient cooling to avoid overheating is recommended. Grinding in fine steps using cooling, light pressure and clean wheels gives smoother finish.

Typical coating properties

Summary of results obtained when spraying with a conventional Arc Spray gun, using varying spraying parameters.

*) These results are obtained when using air as spraying gas. Also nitrogen has been used, resulting in lower rates of porosity and oxides.

Personnel working with thermal spraying should be aware of the hazards connected to the process. They should be familiar with the use of equipment regarding, i.e. eye, skin, hearing and respiratory protection.

Personnel should be familiar with safety regulations regarding the complete process, including spraying and th spray equipment used. This product contains elements, which in certain combinations may be dangerous to your health. Material Safety Data Sheets are provided by Kanthal for this product, and should be read and understood before using the material.

Not following these instructions may danger your health.